标题: [M480] Intelligent Power Station [打印本页] 作者: admin 时间: 2022-11-4 10:30 标题: [M480] Intelligent Power Station
Application: This example code uses M480 GPIO pins to control the relay and MOSFET switches and the Enhance ADC (EADC) with peripheral hardware circuits to measure the AC power currents and USB DC currents that passing thru the enabled AC and USB sockets.
BSP Version: M480 Series BSP CMSIS V3.03.001
Hardware: The M487 Smart Power board but it needs to work with NuMaker-M487D board and DALI master and slave boards.
This example code utilizes the M487 Smart Power board (Ver. 1.1) as the following figure that based on the main controller M487 MCU to control the relay and MOSFET switches by some GPIO pins of MCU and measure the AC power currents and USB DC currents by the Enhance ADC (EADC) of MCU with peripheral hardware circuits.
The Intelligent Power Station hardware consists of three boards, M487 Smart Power board, NuMaker-M487D board and DALI master/slave boards.