牛卧堂MCU技术交流

标题: NUC972开发板linux系统通过USB连接4G模块问题 [打印本页]

作者: 匿名    时间: 2018-11-5 09:13
标题: NUC972开发板linux系统通过USB连接4G模块问题
新塘NUC972开发板,内核linux3.10.x
4G模块为ME909S模块,参照模块移植手册更改
开发板通过USB连接909模块后,如下信息:
usb 1-2: new high-speed USB device number 2 using nuc970-ehci
usb 1-2: device descriptor read/64, error -71
cdc_ether 1-2:2.0 usb0: register 'cdc_ether' at usb-nuc970-ehci-2, CDC Ethernet Device, 02:1e:10:1f:00:00
option 1-2:2.2: GSM modem (1-port) converter detected
usb 1-2: GSM modem (1-port) converter now attached to ttyUSB0
option 1-2:2.3: GSM modem (1-port) converter detected
usb 1-2: GSM modem (1-port) converter now attached to ttyUSB1
option 1-2:2.4: GSM modem (1-port) converter detected
usb 1-2: GSM modem (1-port) converter now attached to ttyUSB2
option 1-2:2.5: GSM modem (1-port) converter detected
usb 1-2: GSM modem (1-port) converter now attached to ttyUSB3
option 1-2:2.6: GSM modem (1-port) converter detected
usb 1-2: GSM modem (1-port) converter now attached to ttyUSB4

没有读出PIDVID等信息,下面的几条ttyusb是不是说USB端口映射成功了,第一次做这种,请问问题出在哪里?
作者: 匿名    时间: 2022-1-14 15:12
解决了没?分享下经验
作者: arthur    时间: 2022-1-14 16:09
usb 1-2: device descriptor read/64, error -71
这个出错意思是"读取描述符“出错,这个跟USB 4G模块的固件有关。请咨询模块厂商。




欢迎光临 牛卧堂MCU技术交流 (http://nuvoton-mcu.com/) Powered by Discuz! X3.2