NUC140VE3CN Example Code for CoOS Free RTOS

1. In general, press the key 1(The first key in Matrix keyboard) will Switch display time and alarm. If now LCD is display the alarm without pressing the key 1 any more, then LCD will display time after 10 seconds.

2. This example simulates a real-time clock and alarm on a 128*64 LCD with which users can set time and alarm freely: key 2 and key 3 could configure the time or alarm which is currently displayed.
Press key 2(The second key in Matrix keyboard) to choose the month, day, hour, minute or second that you want to modify, the selected bit will blink at the same time. When press it 7 times, you will exit the configuration mode.
Press key 3(The third key in Matrix keyboard) to increase the month, day, hour, minute or second which was choosen to modify by key 2.

3. System samples the value of AD at regular intervals and show it by the 7-segment LED. You can adjust the input voltage of AD converter by the regulation resistance on board, and you could see the change on the last three 7-segment LED.

4. The first 7-segment LED will show the key vaule.

5. When the alarm is ringing, press any key will stop it ringing. If you press Key 7, it will end Ring-again mode; if you press the other key, it will ring again after one minute.

System Configuration:

The max user task:10
Enable Mutexes(CFG_MUTEX_EN) and software timer (CFG_TMR_EN).