NUC972 UART RX DMA 问题

目的: 用DMA 把串口9的接收数据放到一个数组代码:
                        CHAR buf[]={0x03,0x03,0x9C,0x4B,0x00,0x01};

                        outpw(REG_GDMA_CTL0, 0x0);
                        outpw(REG_GDMA_SRCB0,REG_UART9_RBR);//source
                        outpw(REG_GDMA_DSTB0,(uint32_t)DMARecBuf);//destination
                        outpw(REG_GDMA_TCNT0,7);

                        outpw(REG_GDMA_CTL0,(1<<7)  | (1<<16));
                        outpw(REG_GDMA_CTL0,inpw(REG_GDMA_CTL0)|1);

                        comSend(buf,6);
                       
                        while(!(inpw(REG_GDMA_INTCS) & 0x100));
                        outpw(REG_GDMA_INTCS,0x100);
问题点                bug = DMARecBuf[0]; //如果增加这一句代码后，就没有接收数据到DMARecBuf

是楼主的 typo 吗？从上面看 GDMA使用的是 Channel 0, 最后却是 REG_GDMA_INTCS: 0x100 设置的是 Channel 1的中断？

Publication Release Date: Dec. 15, 2015
- 321 - Revision V1.30
NUC970 TECHNICAL REFERENCE MANUAL
[8] TC0F
Channel 0 Terminal Count
0 = Channel does not expire.
1 = Channel expires; this bit is set only by GDMA hardware, and clear by software to
write logic 1.
TC0 is the GDMA interrupt flag. TC0 or GDMATERR0 will generate interrupt

参考现有的BSP代码：
NUC980_NonOS_BSP\SampleCode\UART_PDMA